≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
wiki:tools:jaxen_operating [2026/07/28 01:11] – colinlwiki:tools:jaxen_operating [2026/07/28 01:30] (current) – colinl
Line 1: Line 1:
-===== Jaxen CNC Operating Guide =====+====== Jaxen CNC Operating Guide ======
  
 [[jaxen_cnc_mill|Visit Jaxen's homepage here.]] [[jaxen_cnc_mill|Visit Jaxen's homepage here.]]
Line 20: Line 20:
  
  
 +-------------------------
 +==== Training Program ====
  
 +The Training Program for Jaxen will teach you all the following skills:
 +  * General access and group communication when using Jaxen CNC.
 +  * Installing and removing collets/bits safely
 +  * Choosing the right tools for the job
 +  * How to 'drive' Jaxen
 +  * Mapping G-code to physical workpiece coordinates
 +  * Tool depth calibration
 +  * Re-mounting part (multi-job)
 +  * Workpiece holding
 +  * Understanding basic G-Code for troubleshooting and manual data entry
 +  * CAD job prep: For example, choosing inside corner radii based on bits used.
  
  
Line 43: Line 56:
  
 ------------------------- -------------------------
-==== Basic Procedures: ====+==== Basic Milling Procedures: ====
  
  
Line 104: Line 117:
  
  
 +------------
  
- 
-------------------------- 
-Training notes: 
-- Choosing inside corner radii based on bits used. 
- 
- 
- 
-Skills: 
-- Mapping G-code to physical workpiece coordinates 
-- Tool depth calibration 
-- Re-mounting part (multi-job) 
-- workpice holding 
     You MAY need a custom mount if:     You MAY need a custom mount if:
         -You need to mill more than 1 side (having a custom mount allows flipping and matching the alignment)         -You need to mill more than 1 side (having a custom mount allows flipping and matching the alignment)