≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
wiki:tools:jaxen_operating [2026/10/30 23:16] – depths colinlwiki:tools:jaxen_operating [2026/10/30 23:18] (current) – colinl
Line 346: Line 346:
 In this small tutorial, we are going to create a simple surfacing/facing job, to prepare stock for a later project. In this small tutorial, we are going to create a simple surfacing/facing job, to prepare stock for a later project.
  
-Tip: Any mentions of "depth" for any operations are relative to the top surface of the stock that you've setup in FreeCAD. Be sure that this is set how you expect!+Tip: Any mentions of "depth" or "height" for any operations are relative to the top surface of the stock that you've setup in FreeCAD. Be sure that this is set how you expect!
  
   - Select the geometry of your model that will be relevant to this operation. In this case, select the face you want to surface!   - Select the geometry of your model that will be relevant to this operation. In this case, select the face you want to surface!