≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
wiki:tools:jaxen_operating [2026/10/30 22:07] – tool setup colinlwiki:tools:jaxen_operating [2026/10/30 23:18] (current) – colinl
Line 345: Line 345:
  
 In this small tutorial, we are going to create a simple surfacing/facing job, to prepare stock for a later project. In this small tutorial, we are going to create a simple surfacing/facing job, to prepare stock for a later project.
 +
 +Tip: Any mentions of "depth" or "height" for any operations are relative to the top surface of the stock that you've setup in FreeCAD. Be sure that this is set how you expect!
  
   - Select the geometry of your model that will be relevant to this operation. In this case, select the face you want to surface!   - Select the geometry of your model that will be relevant to this operation. In this case, select the face you want to surface!
Line 356: Line 358:
  
 Engraving in FreeCad and converting to toolpaths can be tricky because the methods have changed significantly with recent updates of FreeCAD. Engraving in FreeCad and converting to toolpaths can be tricky because the methods have changed significantly with recent updates of FreeCAD.
 +
 +You may find more info here, but it's not super helpful: [[https://wiki.freecad.org/CAM_Vcarve | VCarve Wiki page]]
  
 The following is for FreeCad 1.1 !!! The following is for FreeCad 1.1 !!!