tutorials:making_a_filament_pulley_or_hobbed_bolt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| tutorials:making_a_filament_pulley_or_hobbed_bolt [2014/07/14 01:19] – ashley | tutorials:making_a_filament_pulley_or_hobbed_bolt [2014/07/14 01:23] – ashley | ||
|---|---|---|---|
| Line 19: | Line 19: | ||
| *Use M8 bolts if possible so they fit standard 608ZZ bearings. The 5/16 bolts were a bit loose. | *Use M8 bolts if possible so they fit standard 608ZZ bearings. The 5/16 bolts were a bit loose. | ||
| *We had some concern about the 3D printed jigs but they were very strong, printed in PET at 100% infill. | *We had some concern about the 3D printed jigs but they were very strong, printed in PET at 100% infill. | ||
| - | *The Tantillus would benefit from having a shorter, Wades' style bolt. They are easier to cut because the teeth are closer to the centre of the bolt and they are easy to source ready-made. | + | *The Tantillus would benefit from having a shorter, Wades' style bolt. They are easier to cut and easy to source ready-made. |
tutorials/making_a_filament_pulley_or_hobbed_bolt.txt · Last modified: 2015/12/12 14:31 by 127.0.0.1