tool:sherline_cnc_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:sherline_cnc_mill [2016/08/03 16:53] – added shutdown i-make-robots | tool:sherline_cnc_mill [2018/03/09 05:01] (current) – Added link to PCB milling with Sherline colorcoded | ||
---|---|---|---|
Line 11: | Line 11: | ||
^ Arrival Date | June 2010 | | ^ Arrival Date | June 2010 | | ||
^ Location | ^ Location | ||
- | ^ Value | $2000 | | ||
^ Champion | ^ Champion | ||
====== Information: | ====== Information: | ||
- | Forum thread: https:// | + | Forum thread: https:// |
For regular mill's operation: | For regular mill's operation: | ||
Line 32: | Line 31: | ||
__Required: | __Required: | ||
* Safety Glasses | * Safety Glasses | ||
- | * Clamping devices (apply https:// | + | * Clamping devices (apply https:// |
* an experienced machine operator (if this is not you, you must get someone to help you!) | * an experienced machine operator (if this is not you, you must get someone to help you!) | ||
* long hair must be tied back | * long hair must be tied back | ||
Line 76: | Line 75: | ||
* Remove your tool(s) from the chuck. | * Remove your tool(s) from the chuck. | ||
* Clean up the cutting leftovers. | * Clean up the cutting leftovers. | ||
+ | |||
+ | ====== PCB Milling ====== | ||
+ | |||
+ | See [[PCB Milling With Sherline]]. | ||
====== Notes for later: ====== | ====== Notes for later: ====== | ||
- Machine zero, work zero and G28: https:// | - Machine zero, work zero and G28: https:// | ||
- | - http:// | + | - http:// |
- | 4 Axis TB6560 Controller board | + | - Tool speed calculator: http:// |
- We have collets for 3mm, 4mm, 6mm and 1/8”, 3/16”, 1/4" shank end mills. | - We have collets for 3mm, 4mm, 6mm and 1/8”, 3/16”, 1/4" shank end mills. | ||
- We have a [[http:// | - We have a [[http:// | ||
- The upper e-stop button should work, but verify that it stops the mill before you begin any real operation. | - The upper e-stop button should work, but verify that it stops the mill before you begin any real operation. |
tool/sherline_cnc_mill.1470243192.txt.gz · Last modified: 2016/08/03 16:53 by i-make-robots