tool:redsail_cm1080_laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:redsail_cm1080_laser_cutter [2019/12/11 23:41] – The materials being cut should not be lasing. thovthe | tool:redsail_cm1080_laser_cutter [2024/04/16 04:48] (current) – Added stepper driver details ddq | ||
---|---|---|---|
Line 6: | Line 6: | ||
Everybody loves lasers | Everybody loves lasers | ||
- | ^ Status | + | ^ Status |
^ Training | ^ Training | ||
^ Hackable | ^ Hackable | ||
Line 42: | Line 42: | ||
* Type: CO2 | * Type: CO2 | ||
* Power: 80W | * Power: 80W | ||
- | * Controller: [[http://www.lightobject.com/ | + | * Controller: [[https:// |
- | * Chiller: [[http://vanhack.ca/doku.php? | + | * Chiller: [[https://lightobject.com/q800-water-chiller/|LightObject Industrial Water Chiller Q800]], [[https:// |
* Power supply: [[http:// | * Power supply: [[http:// | ||
* Input: AC 220V | * Input: AC 220V | ||
Line 52: | Line 52: | ||
* 3pin terminal pinout: G, AC, AC | * 3pin terminal pinout: G, AC, AC | ||
* 6pin terminal pinout: H, L, WP, G, IN, 5V | * 6pin terminal pinout: H, L, WP, G, IN, 5V | ||
+ | * 3-Phase Stepper Motor Drivers: [[https:// | ||
+ | * Note: Different driver models have different pinouts even though the connectors are the same. DO NOT swap connectors without changing the wire order. | ||
+ | * Input: DC 40V | ||
+ | * Motor current: 4A | ||
+ | * Steps/rev: 5000 | ||
+ | * Idle current: half | ||
+ | * Power-on self test: off | ||
===== Usage and Maintenance ===== | ===== Usage and Maintenance ===== |
tool/redsail_cm1080_laser_cutter.1576107685.txt.gz · Last modified: 2019/12/11 23:41 by thovthe