tool:redsail_cm1080_laser_cutter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| tool:redsail_cm1080_laser_cutter [2024/04/11 14:38] – Updated chiller model ddq | tool:redsail_cm1080_laser_cutter [2024/04/16 04:48] (current) – Added stepper driver details ddq | ||
|---|---|---|---|
| Line 52: | Line 52: | ||
| * 3pin terminal pinout: G, AC, AC | * 3pin terminal pinout: G, AC, AC | ||
| * 6pin terminal pinout: H, L, WP, G, IN, 5V | * 6pin terminal pinout: H, L, WP, G, IN, 5V | ||
| + | * 3-Phase Stepper Motor Drivers: [[https:// | ||
| + | * Note: Different driver models have different pinouts even though the connectors are the same. DO NOT swap connectors without changing the wire order. | ||
| + | * Input: DC 40V | ||
| + | * Motor current: 4A | ||
| + | * Steps/rev: 5000 | ||
| + | * Idle current: half | ||
| + | * Power-on self test: off | ||
| ===== Usage and Maintenance ===== | ===== Usage and Maintenance ===== | ||
tool/redsail_cm1080_laser_cutter.txt · Last modified: 2024/04/16 04:48 by ddq