tool:hakko_fx-888d_temperature_controlled_soldering_stations
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
tool:hakko_fx-888d_temperature_controlled_soldering_stations [2014/08/05 22:12] – lytfyre | tool:hakko_fx-888d_temperature_controlled_soldering_stations [2015/12/12 14:31] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 24: | Line 24: | ||
To set the temperature, | To set the temperature, | ||
- | Holidng | + | Holidng |
- | When in calibration mode, the dot beside each digit flashes. | + | |
- | To avoid accidentally putting the irons in calibration mode when trying to set the target temperature, | + | To avoid accidentally putting the irons in calibration mode when trying to set the target temperature, |
Here is the undocumented factory reset procedure to factory reset them: https:// | Here is the undocumented factory reset procedure to factory reset them: https:// |
tool/hakko_fx-888d_temperature_controlled_soldering_stations.txt · Last modified: 2016/06/06 16:55 by bruce