tool:form1sla
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:form1sla [2018/08/22 05:56] – mimi_x | tool:form1sla [2019/04/23 20:52] (current) – 00739 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Form 1 SLA Resin 3D Printer ====== | ====== Form 1 SLA Resin 3D Printer ====== | ||
+ | |||
+ | {{: | ||
Line 12: | Line 14: | ||
^ Location | ^ Location | ||
^ Champion | ^ Champion | ||
- | ====== Information: | + | ===== Information: |
< | < | ||
</ | </ | ||
- | ===General info=== | ||
- | + | ==== Resources | |
- | ==Resources== | + | |
read through the [[https:// | read through the [[https:// | ||
non-official wiki: [[http:// | non-official wiki: [[http:// | ||
- | + | ==== OpenFL | |
- | ==OpenFL== | + | |
See [[https:// | See [[https:// | ||
- | + | ==== Set Up a Print ==== | |
- | ===Set Up a Print=== | + | |
you will need to download the [[https:// | you will need to download the [[https:// | ||
+ | ==== Cleaning Up ==== | ||
+ | < | ||
- | ===Cleaning Up=== | + | ==== How to Clean the Tank ==== |
- | ==how to clean the tank== | + | |
[[https:// | [[https:// | ||
- | |||
- | |||
> 1. Use the scraper to scrape out as much resin as possible. | > 1. Use the scraper to scrape out as much resin as possible. | ||
Line 43: | Line 40: | ||
> 3. Place the resin tank upside down on a paper towel to let the IPA drip out and dry. | > 3. Place the resin tank upside down on a paper towel to let the IPA drip out and dry. | ||
+ | ==== Clean Up After a Successful Print ==== | ||
+ | remove platform from the printer, remove the print | ||
+ | leave resin in tank | ||
+ | ==== Clean Up After a Failed Print ==== | ||
- | ==Clean Up After a Successful Print== | + | Remove platform, remove all cured resin from the tank with spatula. use comb if needed, to filter out small bits. |
- | + | ||
- | ==Clean Up After a Failed Print== | + | |
- | ===Maintenance=== | + | ==== Maintenance |
- | ==tank maintainance== | + | === Tank Maintainance === |
Reapplying PDMS layer in tank: | Reapplying PDMS layer in tank: | ||
[[https:// | [[https:// | ||
+ | === Replacement parts === | ||
+ | Formlabs has officially discontinued the Form1, so parts must be bought from 3rd party suppliers | ||
+ | https:// | ||
tool/form1sla.1534917379.txt.gz · Last modified: 2018/08/22 05:56 by mimi_x