tool:redsail_cm1080_laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
tool:redsail_cm1080_laser_cutter [2024/04/11 14:38] – Updated chiller model ddq | tool:redsail_cm1080_laser_cutter [2024/04/16 04:48] (current) – Added stepper driver details ddq | ||
---|---|---|---|
Line 52: | Line 52: | ||
* 3pin terminal pinout: G, AC, AC | * 3pin terminal pinout: G, AC, AC | ||
* 6pin terminal pinout: H, L, WP, G, IN, 5V | * 6pin terminal pinout: H, L, WP, G, IN, 5V | ||
+ | * 3-Phase Stepper Motor Drivers: [[https:// | ||
+ | * Note: Different driver models have different pinouts even though the connectors are the same. DO NOT swap connectors without changing the wire order. | ||
+ | * Input: DC 40V | ||
+ | * Motor current: 4A | ||
+ | * Steps/rev: 5000 | ||
+ | * Idle current: half | ||
+ | * Power-on self test: off | ||
===== Usage and Maintenance ===== | ===== Usage and Maintenance ===== |
tool/redsail_cm1080_laser_cutter.txt · Last modified: 2024/04/16 04:48 by ddq