tool:green_manual_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:green_manual_mill [2020/03/16 07:23] – billiam | tool:green_manual_mill [2023/02/09 20:43] (current) – Corrected spindle taper to Morse MT3 androidlx | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Manual Mill ====== | ====== Manual Mill ====== | ||
- | ^ Status | + | ^ Status |
^ Training | ^ Training | ||
^ Hackable | ^ Hackable | ||
^ Usage Restrictions | Members Only, only after VHS training / orientation | ^ Usage Restrictions | Members Only, only after VHS training / orientation | ||
- | ^ Owner | (VHS or Name of proper owner) | | + | ^ Owner | Mark Denny (friend |
^ If it Breaks | ^ If it Breaks | ||
- | ^ Loan Status | + | ^ Loan Status |
^ Arrival Date | November 2013 | | ^ Arrival Date | November 2013 | | ||
^ Location | ^ Location | ||
Line 25: | Line 25: | ||
The following information was measured from the mill and may be inaccurate. | The following information was measured from the mill and may be inaccurate. | ||
- | Spindle Taper: | + | Spindle Taper: |
Table: 1/2in T slots | Table: 1/2in T slots |
tool/green_manual_mill.1584343407.txt.gz · Last modified: 2020/03/16 07:23 by billiam