tool:green_manual_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:green_manual_mill [2020/03/16 07:16] – billiam | tool:green_manual_mill [2023/02/09 20:43] (current) – Corrected spindle taper to Morse MT3 androidlx | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Manual Mill ====== | ====== Manual Mill ====== | ||
- | ^ Status | + | ^ Status |
^ Training | ^ Training | ||
^ Hackable | ^ Hackable | ||
- | ^ Usage Restrictions | Members Only | | + | ^ Usage Restrictions | Members Only, only after VHS training / orientation |
- | ^ Owner | (VHS or Name of proper owner) | | + | ^ Owner | Mark Denny (friend |
- | ^ If it Breaks | + | ^ If it Breaks |
- | ^ Loan Status | + | ^ Loan Status |
^ Arrival Date | November 2013 | | ^ Arrival Date | November 2013 | | ||
- | ^ Location | + | ^ Location |
^ Champion | ^ Champion | ||
Line 15: | Line 15: | ||
===== Safety ===== | ===== Safety ===== | ||
- | Always wear eye protection while using the mill. Do not use the mill if you do not know how to use this type of machine. If used improperly; workpieces | + | Always wear eye protection while using the mill. VHS-specific training / orientation is required. If used improperly, workpieces |
===== Specifications: | ===== Specifications: | ||
Line 25: | Line 25: | ||
The following information was measured from the mill and may be inaccurate. | The following information was measured from the mill and may be inaccurate. | ||
- | Spindle Taper: | + | Spindle Taper: |
Table: 1/2in T slots | Table: 1/2in T slots | ||
Line 31: | Line 31: | ||
===== Notes ===== | ===== Notes ===== | ||
- | To move mill head up and down (major vertical adjustment); | + | To move mill head up and down (major vertical adjustment); |
===== Axes ===== | ===== Axes ===== | ||
Line 51: | Line 51: | ||
- Fly cutter. Takes an HSS toolbit, ground to the correct profile | - Fly cutter. Takes an HSS toolbit, ground to the correct profile | ||
- 1/4, 3/8 and 1/2 collets. Used to hold end mills, fly cutters, and the small boring head | - 1/4, 3/8 and 1/2 collets. Used to hold end mills, fly cutters, and the small boring head | ||
- | - 2.5" face mill. Needs to be replaced, as all the carbides are chipped, and are not available for purchase. Still | + | - 2.5" face mill. Needs to be replaced, as all the carbides are chipped, and are not available for purchase. Still works reasonably well |
- | | + | |
- Drift keys. USe to remove the tooling from the spindle. See document (pending) for use. | - Drift keys. USe to remove the tooling from the spindle. See document (pending) for use. | ||
- (many more in varying condition) | - (many more in varying condition) | ||
+ | - (Most) tooling is located in the red toolbox in the end of the (pending) work bench. | ||
===== Speeds & Feeds ===== | ===== Speeds & Feeds ===== | ||
tool/green_manual_mill.1584343008.txt.gz · Last modified: 2020/03/16 07:16 by billiam