tool:smd_reflow_oven
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
tool:smd_reflow_oven [2021/07/15 19:07] – packetbob | tool:smd_reflow_oven [2021/07/15 19:09] – packetbob | ||
---|---|---|---|
Line 57: | Line 57: | ||
10) Select the **Run Profile** button and the oven will start the reflow cycle. The screen will show the progress on a small graph. | 10) Select the **Run Profile** button and the oven will start the reflow cycle. The screen will show the progress on a small graph. | ||
- | {{:tool:oven4.png?400|}} | + | {{:tool:oven3.png?400|}} |
11) Once the reflow cycle is completed the oven will open the door to allow the oven to cool. | 11) Once the reflow cycle is completed the oven will open the door to allow the oven to cool. | ||
12) Once the oven has cooled to 100C the oven screen will say it is OK to remove your PCB Note that you need to use tweezers as the boards will be hot… Really really hot… Like burn your friggin fingers even though you should know better hot... | 12) Once the oven has cooled to 100C the oven screen will say it is OK to remove your PCB Note that you need to use tweezers as the boards will be hot… Really really hot… Like burn your friggin fingers even though you should know better hot... | ||
+ | |||
+ | {{: | ||
13) Once the oven has cooled to 50C the oven door closes. This is a better time to remove your PCB. | 13) Once the oven has cooled to 50C the oven door closes. This is a better time to remove your PCB. |
tool/smd_reflow_oven.txt · Last modified: 2021/07/15 19:09 by packetbob