≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
wiki:groups:lasercutter:start [2026/02/17 11:29] – adminwiki:groups:lasercutter:start [2026/02/17 12:19] (current) – admin
Line 1: Line 1:
 <!DOCTYPE markdown> <!DOCTYPE markdown>
-# Laser Cuttering and Engraving at VHS+# Laser Cutting and Engraving at VHS
  
 One of VHS' most popular tools, our [80W CO2 Laser Cutter](/wiki/tools/redsail_cm1080_laser_cutter), and the associated [filtration system](/wiki/tools/laserfilter), is managed by the [Laser Cutter Committee (LCC)](wiki:committees:lcc). The laser cutter area is located just past the entrance to the paint and mess room, along the west wall of the space. One of VHS' most popular tools, our [80W CO2 Laser Cutter](/wiki/tools/redsail_cm1080_laser_cutter), and the associated [filtration system](/wiki/tools/laserfilter), is managed by the [Laser Cutter Committee (LCC)](wiki:committees:lcc). The laser cutter area is located just past the entrance to the paint and mess room, along the west wall of the space.
Line 22: Line 22:
  
 <alert danger> <alert danger>
-Only approved materials may be cut on the laser. Violating this rule is grounds for suspension of membership - it puts yourself, other members, and the tool in danger!+**Only approved materials may be cut on the laser**. Violating this rule could lead to suspension of membership - it puts yourself, other members, and the tool in danger!
 </alert> </alert>