≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
wiki:tools:laser_cutter:settings [2026/02/12 11:18] – adminwiki:groups:lasercutter:settings [2026/03/21 14:08] (current) – ddq
Line 6: Line 6:
 ===== Papers ===== ===== Papers =====
 ^ Material ^ Mode ^ Speed ^ Power ^ Corner Power ^ Passes ^ Notes ^ ^ Material ^ Mode ^ Speed ^ Power ^ Corner Power ^ Passes ^ Notes ^
-| Card Stock | Etch | 35 | 10 | 10 | 1 |    | +| Card Stock | Etch | 300 | 10 | 10 | 1 |  Power settings below 10% did not produce any marks at this speed | 
-| Card Stock | Cut | 35 | 35 | 25 | 1 |    |+| Card Stock | Cut | 300 | 20 | 15 | 1 |    |
 | Heavy paper | Cut | 200 | 20 | 20 | 1 | Worked barely; long straight cuts needed multiple passes, and a few corners were missed. Use lower speed | | Heavy paper | Cut | 200 | 20 | 20 | 1 | Worked barely; long straight cuts needed multiple passes, and a few corners were missed. Use lower speed |
 | Picture Matting | Cut | 40 | 50 | 40 | 1 |    | | Picture Matting | Cut | 40 | 50 | 40 | 1 |    |