no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+==== OpenWRT on the WRTU54G-TM ====
+\\
+\\
+Download: [[https://dl.dropboxusercontent.com/s/c70bduwu4hg2hxm/openwrt-WRTU54G-TM.7z|openwrt-WRTU54G-TM.7z]] or alternative link here [[https://drive.google.com/file/d/0B3uMpbwOyYIaRDVMYzBUc29mOFU/edit?usp=sharing|openwrt-WRTU54G-TM.7z]]\\
+\\
+\\
+=== Resetting stock firmware to default settings ===
+)Unplug the power from the device\\
+)Plug the power back into the device and wait 30 seconds\\
+)Using a pin, press and hold the button right beside the port labeled "PHONE2" (its red) for 30 seconds\\
+)Keep the button pressed down and unplug the power for 30 seconds.\\
+)Keep the button pressed down and plug the power in for 30 seconds.\\
+)Finally let go of the button and power cycle the device by unplugging and plugging the power back in.\\
+\\
+\\
+=== Flashing procedures: ===
+\\
+)Reset the device to default settings (See above)\\
+)Connect an ethernet cable from your computer to the router\\
+)Once you've gotten an IP from the router go to http://192.168.0.1\\
+)Log on using the username "admin" and the password "admin"\\
+)Rename "openwrt-adm8668-squashfs.bin" to "WRTU54G-TM_v1.00.26.bin" **IVE ALREADY DONE THIS**\\
+)Press the "Administration" link at the top right, and then press "Firmware Upgrade" link or just use this url: http://192.168.0.1/Firmware-Upgrade.htm and upload openwrt-WRTU54G-TM/12.09-rc2/WRTU54G-TM_v1.00.26.bin\\
+)Wait until the url changes to http://192.168.0.1/OK.htm and you see "Upgrade is successful."\\
+)Unplug your ethernet cable and plug it back in so that you get a new ip from the router. (or disable and renable the network device, or linux users can do "dhclient eth0".)\\
+)Go to http://192.168.1.1 set the password for the device.\\