Differences

This shows you the differences between two versions of the page.

--- tool:thickness_sander [2021/08/11 16:26] – mike
+++ tool:thickness_sander [2023/02/02 15:34] (current) – phillip_ma
@@ Line 8: / Line 8: @@
 across the length of a piece of wood.
-^ Status             | Currently under repair                                                 |
+^ Status             | Operational                                                 |
 ^ Training           | Wiki Training REQUIRED - Easy to Damage                                |
 ^ Hackable           | NO                                                                     |
@@ Line 53: / Line 53: @@
   * Watch some videos on Youtube about how to use a thickness sander
-  * Start with a pass where you aren't sanding anything so that you know you aren't cutting too deep and progress it no more than a quarter turn each time.
+  * Start with a pass where you aren't sanding anything so that you know you aren't cutting too deep and progress it no more than a 16th of a turn.
   * Don't stand directly behind the piece similar to a planer or table saw
   * Before using, make sure the drum has the sandpaper securely attached and the sandpaper is clean, if the sandpaper isn't clean, use the crepe block.
@@ Line 82: / Line 82: @@
 | Replaced with Delta | 2018         | Michael K. |
 | Out of service for repair | 6 Jan, 2021 | Michael K. |
-| Planned Removal | 8/30/2021 | Michael K. |
+| Planned Removal | 30 Aug, 2021 | Michael K. |
+| Planer Tuneup and trainers trained (phillip_m and yeungx) | January 2022 | Phillip M |
+| Drive belt for sanding Drum replaced since it broke, Beveled gears controlling lift mechanism replaced with steel gears.  The original plastic gears were stripping regularly. | May 2022 | Phillip M |
+| Motor for the conveyor belt repaired.  Magnet in the motor was loose causing the noise and ultimately seizing the motor, Reported belt tracking may still be a bit off. | December 2022 | AndroidLx |
+| Motor for the conveyor belt seized again shortly after it was reinstalled.  The motor was stripped down and a wire leading to the electromagnet was sodered into place  | January 2023 | John C and Shane M. |