tool:mendel_max_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| tool:mendel_max_3d_printer [2014/02/24 00:26] – 2014-02-22 update i-make-robots | tool:mendel_max_3d_printer [2014/02/24 19:57] – i-make-robots | ||
|---|---|---|---|
| Line 16: | Line 16: | ||
| ^ Value | $$ | | ^ Value | $$ | | ||
| ^ Champion | ^ Champion | ||
| + | |||
| + | [[3D printer training guide]] | ||
| __** Feb 22 Update**__ | __** Feb 22 Update**__ | ||
| - Nozzle is unblocked and reassembled. | - Nozzle is unblocked and reassembled. | ||
| + | |||
| - PIDs for bed and nozzle appear to be wrong: they refuse to heat to the desired temperature. | - PIDs for bed and nozzle appear to be wrong: they refuse to heat to the desired temperature. | ||
| + | |||
| - Bed needs to be re-levelled. | - Bed needs to be re-levelled. | ||
| + | |||
| - extrusion rate needs to be recalculated. | - extrusion rate needs to be recalculated. | ||
| + | |||
| - z height sensor is loose and should be tightened. | - z height sensor is loose and should be tightened. | ||
tool/mendel_max_3d_printer.txt · Last modified: 2015/12/12 14:31 by 127.0.0.1