User Tools

Site Tools


tool:laser_cutter:workflow_tips

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
tool:laser_cutter:workflow_tips [2017/10/31 18:58] jdmctool:laser_cutter:workflow_tips [2017/10/31 18:59] jdmc
Line 27: Line 27:
  
 ==== FURTHER INFORMATION ==== ==== FURTHER INFORMATION ====
-  * [[http://www.marginallyclever.com/blog/2013/02/three-secrets-to-better-results-on-a-redsail-laser-cutter/|3 secrets to better results]] 
   * [[tool:laser_cutter:aligning|Aligning the final stage of the Redsail Laser Cutter]]   * [[tool:laser_cutter:aligning|Aligning the final stage of the Redsail Laser Cutter]]
   * [[tool:RedSail_CM1080_Laser_Cutter|RedSail CM1080 Laser Cutter specifications]]   * [[tool:RedSail_CM1080_Laser_Cutter|RedSail CM1080 Laser Cutter specifications]]
   * [[tool:laser_cutter:operation_manual|Laser Cutter Operation Manual]]   * [[tool:laser_cutter:operation_manual|Laser Cutter Operation Manual]]
   * [[tool:laser_cutter:settings|Materials and Settings Chart]]   * [[tool:laser_cutter:settings|Materials and Settings Chart]]
tool/laser_cutter/workflow_tips.txt · Last modified: 2020/02/05 05:33 by thovthe

Except where otherwise noted, content on this wiki is licensed under the following license: Public Domain
Public Domain Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki