tool:jointer
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
tool:jointer [2019/02/11 22:57] – mike | tool:jointer [2019/02/18 01:45] – lbuchy | ||
---|---|---|---|
Line 66: | Line 66: | ||
- Additional rules to come | - Additional rules to come | ||
+ | |||
+ | ====== Maintenance ====== | ||
+ | |||
+ | __Blade Replacement__ | ||
+ | |||
+ | February 17, 2019 | ||
+ | By: Logan Buchy | ||
+ | |||
+ | The jointer blades were replaced with new ones (Powertec 148030). | ||
+ | |||
+ | Tools: | ||
+ | * 3mm hex wrench | ||
+ | * Ruler | ||
+ | |||
+ | Step 1. Remove the safety guard | ||
+ | On the Delta 37-190C usually one can just pull the safety guard right out of its holder. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Step 2: Move fence all the way to the furthest back position. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Step 3: Clean out the slot where the jointer blades sit. There is likely to be pitch and sawdust caught in there. | ||
+ | |||
+ | Step 4: Install the jointer blade such that the bevel is on top of the drum. Position the knife hold mechnism (has 4 jack screws) and loosen the jack screws so that the knife and mechanism rest in the drum carriage but not tightly. | ||
+ | |||
+ | Step 5: Measure the straight edge of a piece of plywood with a 1/4" marking. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Step 6: With the fence all the way at the back, rotate the drum in the normal direction of travel. | ||
+ | |||
+ | Once you are happy with where it is, tighten the jack screws. | ||
+ | |||
+ | Step 7: Repeat with the other 2 knives. | ||
+ | |||
+ | Step 8: Check again that all knives are still in the correct position. |
tool/jointer.txt · Last modified: 2019/02/18 01:54 by lbuchy