Vancouver Hack Space

User Tools

Site Tools

You are here: start » tool » jointer
tool:jointer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
tool:jointer [2019/02/18 01:45] – lbuchytool:jointer [2019/02/18 01:54] (current) – lbuchy
Line 100: Line 100:
  
 Once you are happy with where it is, tighten the jack screws.  Check again with the plywood to make sure the blade didn't shift while you tightened (it usually does, it can help to hold the blade down with the ends of your fingers on the bevel). Once you are happy with where it is, tighten the jack screws.  Check again with the plywood to make sure the blade didn't shift while you tightened (it usually does, it can help to hold the blade down with the ends of your fingers on the bevel).
 +
 +[[https://youtu.be/1pZb1CLk5a0|Video showing this procedure]]
  
 Step 7: Repeat with the other 2 knives.  Step 7: Repeat with the other 2 knives. 
  
 Step 8: Check again that all knives are still in the correct position. Step 8: Check again that all knives are still in the correct position.
tool/jointer.txt · Last modified: 2019/02/18 01:54 by lbuchy
Except where otherwise noted, content on this wiki is licensed under the following license: Public Domain
Public Domain Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki