Differences

This shows you the differences between two versions of the page.

--- tool:green_manual_mill [2020/03/16 07:23] – billiam
+++ tool:green_manual_mill [2023/02/09 20:43] (current) – Corrected spindle taper to Morse MT3 androidlx
@@ Line 1: / Line 1: @@
 ====== Manual Mill ======
-^ Status             | Operational as of March 2020                           |
+^ Status             | Operational as of February 2021                          |
 ^ Training           | Required                                       |
 ^ Hackable           | NO                                                              |
 ^ Usage Restrictions | Members Only, only after VHS training / orientation                     |
-^ Owner              | (VHS or Name of proper owner)                                          |
+^ Owner              | Mark Denny (friend of JohnC)                                          |
 ^ If it Breaks       | Attach "Out of Order" sign / note. Post to Talk and Slack, contact area Champions   |
-^ Loan Status        | Temporary                  |
+^ Loan Status        | Long Term Loan                 |
 ^ Arrival Date       | November 2013                                                                   |
 ^ Location           | Machine Shop                                      |
@@ Line 25: / Line 25: @@
 The following information was measured from the mill and may be inaccurate.
-Spindle Taper: Measured ~3.215in long, 0.8in minor diameter, 0.95in major diameter. Very close to Morse #3
+Spindle Taper: MT3 - Morse Taper #3
 Table: 1/2in T slots