Differences

This shows you the differences between two versions of the page.

--- tool:green_manual_mill [2017/07/25 00:02] – Added link to pdf manual for mill majicj
+++ tool:green_manual_mill [2020/03/16 07:16] – billiam
@@ Line 41: / Line 41: @@
 ===== Fixtures =====
-We have a drilling vise intended for use with this mill that clamps to the mill table.
+The 3.5" swivel vise can be bolted to the table via T nuts / bolts. Never assume that the vise is aligned correctly; use a dial indicator to check.
 We have a set of 1/2in T nuts + fingers + step blocks for the CNC mill that will also fit this mill.
@@ Line 47: / Line 47: @@
 ===== Tooling =====
-- Drill Chuck
+- Drill Chuck - at the moment, the only chuck key that fits is on the drill press in the Fab shop area.
+- 2x Offset boring heads
+- Fly cutter. Takes an HSS toolbit, ground to the correct profile
+- 1/4, 3/8 and 1/2 collets. Used to hold end mills, fly cutters, and the small boring head
+- 2.5" face mill. Needs to be replaced, as all the carbides are chipped, and are not available for purchase. Still
+  works reasonably well
+- Drift keys. USe to remove the tooling from the spindle. See document (pending) for use.
 - (many more in varying condition)
@@ Line 65: / Line 71: @@
 | Vice alined and bolted to table | Nov 26, 2013 | QuanaParker |
 | Tool/Work bench built  {{::tool:grizzly_toolbench_img_3981.jpg?200}} {{::tool:grizzly_toolbench_img_3983.jpg?200}} | Nov 26, 2013 | QuanaParker |
+| New drawbar, drift keys | Feb 2020 | Billiam |