tool:form1sla
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:form1sla [2018/08/22 05:35] – mimi_x | tool:form1sla [2019/04/23 20:52] (current) – 00739 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Form 1 SLA Resin 3D Printer ====== | ====== Form 1 SLA Resin 3D Printer ====== | ||
+ | |||
+ | {{: | ||
Line 12: | Line 14: | ||
^ Location | ^ Location | ||
^ Champion | ^ Champion | ||
- | ====== Information: | + | ===== Information: |
+ | < | ||
+ | </ | ||
- | ===General info=== | + | ==== Resources |
+ | read through the [[https:// | ||
- | ==Recommended reading | + | non-official wiki: [[http:// |
- | + | ==== OpenFL | |
- | =OpenFL= | + | |
See [[https:// | See [[https:// | ||
- | ===Set Up a Print=== | + | ==== Set Up a Print ==== |
- | ===Cleaning Up=== | + | you will need to download |
- | =how to clean the tank= | + | |
- | [[https://forum.formlabs.com/t/form1-emptying-and-cleaning-inside-of-resin-tank/ | + | |
+ | ==== Cleaning Up ==== | ||
+ | < | ||
- | < | + | ==== How to Clean the Tank ==== |
- | 1. | + | [[https:// |
- | 2. Use the squirt bottle to squirt IPA into the tank while holding the tank upside down so the IPA can drip out. You don’t want the liquid pooling in the resin tank as it could seep under the silicone, destroying the tank. You can use the scraper to wipe the silicone. | + | |
- | 3. Place the resin tank upside down on a paper towel to let the IPA drip out and dry. | + | |
- | </ | + | |
+ | > 1. Use the scraper to scrape out as much resin as possible. | ||
+ | > 2. Use the squirt bottle to squirt IPA into the tank while holding the tank upside down so the IPA can drip out. You don’t want the liquid pooling in the resin tank as it could seep under the silicone, destroying the tank. You can use the scraper to wipe the silicone. | ||
+ | > 3. Place the resin tank upside down on a paper towel to let the IPA drip out and dry. | ||
- | ==Clean Up After a Successful Print== | + | ==== Clean Up After a Successful Print ==== |
- | ==Clean Up After a Failed Print== | + | remove platform from the printer, remove the print |
+ | leave resin in tank | ||
+ | ==== Clean Up After a Failed Print ==== | ||
+ | Remove platform, remove all cured resin from the tank with spatula. use comb if needed, to filter out small bits. | ||
+ | ==== Maintenance ==== | ||
+ | === Tank Maintainance === | ||
+ | Reapplying PDMS layer in tank: | ||
+ | [[https:// | ||
+ | === Replacement parts === | ||
+ | Formlabs has officially discontinued the Form1, so parts must be bought from 3rd party suppliers | ||
+ | https:// | ||
tool/form1sla.1534916125.txt.gz · Last modified: 2018/08/22 05:35 by mimi_x