tool:6040_cnc_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tool:6040_cnc_mill [2019/07/13 22:29] – jim_stamper | tool:6040_cnc_mill [2020/09/02 20:00] (current) – lukecyca | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | New CNC Mill Donation by Jim Stamper | + | ====== 6040 CNC Mill ====== |
+ | ^ model | YOOCNC 6040Z S80 (Parallel port version) | | ||
+ | ^ Status | ||
+ | ^ Usage Restrictions | Members with Training | ||
+ | ^ Training | ||
+ | ^ User certification required | YES | | ||
+ | ^ Hackable | ||
+ | ^ Owner | Jim Stamper | ||
+ | ^ If it Breaks | ||
+ | ^ Loan Status | ||
+ | ^ Arrival Date | September 2019 | | ||
+ | ^ Location | ||
+ | ^ Champion | ||
- | Wiki in progress. | ||
Machine is in the process of being set up and tested. | Machine is in the process of being set up and tested. | ||
- | Please do not use it without Jim's permission until everthing | + | Please do not use it without Jim's permission until everything |
+ | |||
+ | If you would like to read over the manual, there is a digital version stored on the control box and a paper copy stored with the machine. | ||
thank you | thank you | ||
+ | |||
+ | ===== Startup Procedure ===== | ||
+ | |||
+ | - Turn on controller power (red switch) | ||
+ | - Login to computer (ask on slack #cnc for password if you have been trained) | ||
+ | - Start Mach3mill | ||
+ | |||
+ | ==== Homing ==== | ||
+ | |||
+ | Homing is currently manual. The machine should already be homed. If not: | ||
+ | |||
+ | - Enable Mach3 by pressing reset if necessary | ||
+ | - Drive the machine to the back, right, top position (be careful to not overdrive the machine into the endstops) | ||
+ | - Click "Ref All Home" | ||
+ | - Ensure soft limits are enabled | ||
+ | |||
+ | ==== Running ==== | ||
+ | |||
+ | * Ensure Softlimits are on. If you are getting softlimits warnings, make sure the machine is homed correctly, and then reload your gcode. If you still get softlimit warnings, please ask before continuing! | ||
+ | * To turn the spindle on, use the green " | ||
+ | |||
+ | |||
+ | ===== Shutdown Procedure ===== | ||
+ | |||
+ | * Put away endmills and clamping gear | ||
+ | * Leave the machine in the home position | ||
+ | * Clean up your mess | ||
+ | * Shutdown the computer |
tool/6040_cnc_mill.1563056953.txt.gz · Last modified: 2019/07/13 22:29 by jim_stamper