hacks:pcb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| hacks:pcb [2014/03/07 21:51] – jarrett | hacks:pcb [2014/03/21 03:43] – jarrett | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| ==== Toner Transfer ==== | ==== Toner Transfer ==== | ||
| - | __Works.__ | + | __Works.__ |
| The traces are laser-printed in reverse onto some sort of glossy paper (e.g. magazine or photo paper), then transferred to a copper-clad board using a hot clothing iron or t-shirt press. The traces transfer to the board and act as an etch-resist. | The traces are laser-printed in reverse onto some sort of glossy paper (e.g. magazine or photo paper), then transferred to a copper-clad board using a hot clothing iron or t-shirt press. The traces transfer to the board and act as an etch-resist. | ||
| + | [[http:// | ||
| Issues: | Issues: | ||
| Line 170: | Line 171: | ||
| ==== 3D Printer ==== | ==== 3D Printer ==== | ||
| - | __Has potential.__ | + | __Doesn' |
| - | Single layer of plastic laid down as etch resist. | + | Single layer of plastic laid down as etch resist. Laying down conductive material may soon be an option. |
| Issues: | Issues: | ||
| * Accuracy. Print heads tend to be at least 0.35mm. | * Accuracy. Print heads tend to be at least 0.35mm. | ||
| + | * Plastic shrinkage. | ||
| + | * Will not stick to copper. | ||
| ===== Mechanical ===== | ===== Mechanical ===== | ||
hacks/pcb.txt · Last modified: 2015/12/12 14:31 by 127.0.0.1