====== Information: ======
  * **owner** = Vancouver Hack Space
  * **user certification required** = no
  * **hackable** = No (See tips below)
  * **model** = Hakko FX-888D
  * **serial #** =
  * **how many do we have?** = 3
  * **arrived** = May 2013
  * **does it work?** = Works
  * **if it breaks** = Unplug machine, put a "broken" sign on machine, contact VHS email list.
  * **contact** = VHS email list
  * **where** = Above the electronics test area
  * **replacement value** = $100 each



====== Operation Details ======

Hakko FX-888D irons use Hakko T18 Series tips

This is one of the better videos about soldering:
http://www.youtube.com/watch?v=I_NU2ruzyc4

The UI of these stations are a bit confusing. 

To set the temperature, hold **ENTER** until the numbers start flashing, then use **UP** to increment the flashing digit, and **ENTER** to move to the next digit. 

Holidng **UP** puts the iron in calibration mode, which allows you to input the current temperature of the iron, to program an offset. Use a soldering iron thermometer to determine this temperature. 

To avoid accidentally putting the irons in calibration mode when trying to set the target temperature, we have enabled the password lockout on them - a code is required to enter the calibration mode. the code on all three of our irons is **"abc"**

Here is the undocumented factory reset procedure to factory reset them: https://www.youtube.com/watch?v=ecH4c6NdBuo
Instructions from the above video, and updated from this [[http://forums.adafruit.com/viewtopic.php?f=44&t=37070&p=239785#p245387|Adafruit forum thread]]:

  * Press and hold **Up** and **Enter** buttons, then turn station on
  * Continue holding until display flashes 'A'
  * For Celsius, press **Enter**
  * For Fahrenheit, press **Up** (display should flash 'U') then press **Enter**

The soldering station should now return to normal operation, with factory calibration.