Differences

This shows you the differences between two versions of the page.

--- tool:video_wall [2020/03/07 01:14] – dbynoe
+++ tool:video_wall [2024/05/18 03:26] (current) – dbynoe
@@ Line 8: / Line 8: @@
 ^ Hackable           | Software on the computer - Yes |
 ^ | Hardware - Probably not a good idea|
-^ |Firmware on the FPGA's (sender and reciever cards) - Very not advised unless you know what you are doing  |
+^ |Firmware on the FPGA's (sender and reciever cards) - Very not advised unless you know what you are doing password at bottom section of this page |
 ^ Usage Restrictions | None|
 ^ Owner              | VHS|
@@ Line 88: / Line 88: @@
+ ==== Setting password ====
+ DO YOU NEED THE PASSWORD FOR THE PARA SETTINGS?
+ READ THIS FIRST!!!!
+ YOU CAN DESTROY THIS DEVICE WITH THE WRONG SETTINGS
+ THIS IS NOT A JOKE
+ Rule 1. DO NOT CHANGE ANYTHING ON THE RIGHT SIDE OF THE PROGRAM ESPECIALLY SCREEN OPTIONS AND RECIEVER CARD AREAS
+ hitting apply will overwrite the current settings
+ which we do not have a backup for THEY ARE UNRECOVERABLE.
+ I spent over a month trying to recreate them using a spare reciever card
+ It did not work, DO NOT ATTEMPT TO FIGURE IT OUT WITHOUT FIRST TALKING TO @dbynoe, there is no recovery possible, YOU WILL DESTROY THE DISPLAY, no take backsies. I spent a lot of time to build this, a ton of hours figuring out how to make it work, and a bunch of hours, donated a decent chunk of cash to buy the sender card. DONT FUCK IT UP. thank you.
+ Rule 6. Limit brightness to below 20%, 100% will draw up to 30amps.
+ Rule 8: note that that you have been made aware of a very limited subset of the potential hazards contact @dbynoe on talk/slack if you really want to play with this.
+ Rule 10: the password is the numbers of the above rules in order, only change settings under screen display (brightness, but keep it under 20%) or output area of image