tool:6040_cnc_mill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
tool:6040_cnc_mill [2020/09/02 20:00] – Startup and shutdown procedure lukecyca | tool:6040_cnc_mill [2020/09/02 20:00] (current) – lukecyca | ||
---|---|---|---|
Line 23: | Line 23: | ||
- | ==== Startup Procedure ==== | + | ===== Startup Procedure |
- Turn on controller power (red switch) | - Turn on controller power (red switch) | ||
Line 29: | Line 29: | ||
- Start Mach3mill | - Start Mach3mill | ||
- | ===== Homing | + | ==== Homing ==== |
- | Homing is currently manual. | + | Homing is currently manual. |
- Enable Mach3 by pressing reset if necessary | - Enable Mach3 by pressing reset if necessary | ||
Line 38: | Line 38: | ||
- Ensure soft limits are enabled | - Ensure soft limits are enabled | ||
- | ===== Running | + | ==== Running ==== |
* Ensure Softlimits are on. If you are getting softlimits warnings, make sure the machine is homed correctly, and then reload your gcode. If you still get softlimit warnings, please ask before continuing! | * Ensure Softlimits are on. If you are getting softlimits warnings, make sure the machine is homed correctly, and then reload your gcode. If you still get softlimit warnings, please ask before continuing! | ||
Line 44: | Line 44: | ||
- | ==== Shutdown Procedure ==== | + | ===== Shutdown Procedure |
* Put away endmills and clamping gear | * Put away endmills and clamping gear |
tool/6040_cnc_mill.txt · Last modified: 2020/09/02 20:00 by lukecyca